Getting Started


Common Problems If your post ends up in here, don’t feel singled out - Quite the opposite - your issue is something that so many people run into that we’re putting it here to help other new users.
First time users - welcome! [Getting Started] (2)

If you’ve never used LightBurn before, here are a few general usage videos to help get you going: Device setup: https://www.youtube.com/watch?v=1UygQiNqSQA Interface walkthrough: https://www.youtube.com/watch?v=uzFsrU…

About the Getting Started category [Getting Started] (1)
Camera setup hdmi [Common Problems] (2)
Any other OSX users out there? ( 2 ) [Getting Started] (28)
How to adjust my laser in lightburn [Getting Started] (14)
New user looking for suggestions for a K40 Ramps 1.4 setup ( 2 ) [Getting Started] (23)
Which Lightburn Camera? [Getting Started] (8)
New LightBurn User with Questions Settings and Device setup ( 2 ) [Getting Started] (35)
Settings needed to export Lbrn with correct cut settings [Getting Started] (5)
Lightburn on Linux ( 2 ) [Getting Started] (22)
Light burn and 3018 Pro [Getting Started] (10)
Help with weld in LB [Common Problems] (3)
Couple of basic questions ref; origin / stopping [Getting Started] (14)
Blue scren on trial version [Getting Started] (13)
Prix licence finale [Getting Started] (16)
Scanning modes - smooth scanning vs discreet [Getting Started] (12)
Configuring a home install for a Makerspace member [Getting Started] (5)
Losing Network Connectivity since 9.0.02 [Common Problems] (6)
Fire Button Working intermittently [Getting Started] (3)
Questions regarding Lightburn and Engraver ( 2 3 4 ) [Getting Started] (65)
Another Rotary Setup Question [Getting Started] (6)
Mirrored image using rotary [Common Problems] (10)
Flaws in Burn - Need Help [Getting Started] (4)
Project opening with old cut settings [Common Problems] (3)
Engraving on a Chinese 50w laser [Getting Started] (3)
X controller directions reversed [Common Problems] (10)
What happend to Cut, Scan and Scan&Cut - It's now Line, Fill and Fill&Line? [Getting Started] (4)
Check Size button [Getting Started] (6)
New user trying to link machine USB failing [Getting Started] (6)
Rubber stamp created [Getting Started] (4)