Getting Started   Common Problems


Topic Replies Activity
About the Common Problems category 1 March 21, 2019
Will not reset to zero 13 November 15, 2019
different lines at X and Y axis 23 November 14, 2019
Double Stoke Fonts 3 November 7, 2019
Create several cuts in the same job 4 November 2, 2019
Line error 25, laser stops? 11 November 1, 2019
EleksMaker® EleksLaser A3X-2500mw Laser Engraving Machine Interface 7 October 30, 2019
White parts are engraved 8 October 29, 2019
Getting actual bed location to align with page 7 November 14, 2019
Laser prints everything in reverse 12 November 12, 2019
Position error on Y Axis only 17 November 4, 2019
Transfer failed 7 October 19, 2019
Software can't find my laser 6 October 11, 2019
Fill + Line / Scan 3 October 1, 2019
Jog is reversed but manual commands work in the correct direction GRBL 1.1 7 September 24, 2019
Help needed job origin 6 September 21, 2019
Eleksmaker A3 2500mw laser - won't burn anything 6 September 17, 2019
Slow moves not switching laser off during travel 7 September 3, 2019
Newbie Orientation Question 7 August 24, 2019
. 04 release changes 6 July 31, 2019
Job starting problems 4 July 22, 2019
Laser not cutting to scale 7 July 15, 2019
When cutting, and passes set to 1, my laser is cutting with two passes 7 July 14, 2019
Edit imported traced graphic 13 July 11, 2019
Negative Coordinate Machine Setup 2 July 4, 2019
Installed C3D laser board, installed device, shows disconnected 7 June 26, 2019
Waiting for connection... Waiting for connection 7 June 21, 2019
Not Sure why the Boolean Is doing this 5 June 20, 2019
Burn not even and edges are too dark 3 June 5, 2019
DXF file from Corel imports with wrong size 7 June 5, 2019