Hardware


Cameras Anything related to camera use with LightBurn - models, setup, etc. Marlin Marlin specific configuration, settings, and issues. TopWisdom controllers TopWisdom specific configuration, settings, and issues. Smoothieware Smoothieware specific configuration, settings, and issues. Ruida controllers Ruida specific configuration, settings, and issues. GRBL GRBL specific configuration, settings, and issues. Trocen AWC controllers Trocen specific configuration, settings, and issues.
Topic Replies Activity
About the Hardware category 4 May 7, 2019
Grbl Mega 5X, RAMPS Board, TTL Laser pin solution 3 April 4, 2020
Laser output Information 1 April 4, 2020
Mac doesn't connect to Ruida, using USB c 9 April 4, 2020
What is this and what can I replace it with? 18 April 4, 2020
No 24v power from supply 10 April 4, 2020
Setting 0 working point on bottom left corner - Chinese 70x50, Ruida644XS 6 April 3, 2020
Lightburn camera setup 2 April 3, 2020
Ortur Laser Master and Laser Master 2 Firmware Updates 1.34 122 April 2, 2020
Mangled G-code / shifted elements - Arduino/Marlin/RAMPS problem? 1 April 2, 2020
Start from point - Trocen 2 April 2, 2020
What actually happens behind the curtain when the rotary is enabled? 8 April 2, 2020
How do i set speed 17 April 2, 2020
First install for new machine 7 April 2, 2020
Current TopWisdom development status 3 March 29, 2020
Can a Wyze cam be set to work as the Lightburn Cam? 8 April 1, 2020
Camera selection causing crash 11 April 1, 2020
Camera Alignment Issues 19 March 31, 2020
What is meant by the "series" of a laser? 9 March 30, 2020
Know where to get an18 mm mirror? 8 March 30, 2020
Laser not burning 9 March 30, 2020
Further Fabrication Build, Ruida controller was working, now its dead 7 March 30, 2020
Homing problem after Rotary axis 2 March 30, 2020
Camera issue with 0.9.11 11 March 30, 2020
Air assist enabled 4 March 30, 2020
Camera alignment retention is poor? 25 March 29, 2020
Laser burns during the movement of a scratching the entire image 5 March 29, 2020
Lightburn 8MP freezing 4 March 29, 2020
I Need Vendor Settings For My Machine 1 March 29, 2020
Random GRBL errors 2 March 29, 2020