2watt 1064nm infared conversion

[MikeyH (Mike Hembrey)]

You may find what you are looking for here…

Sculpfun IR2 infrared laser settings in Lightburn

This is an official video but the settings are suggestions, so you may need to try it a bit. [!! LEVEL UP !! Sculpfun 1064nm infrared Laser Module IR-2 for plastic and metal engraving] Setting used are: Stainless steel 1000 mm/m with an interval of 0.01 mm 2000 - 3000mm/m with interval of 0.02 / 0.03mm for plastic 6000 mm/m and 0.03mm interval. Now it is said that running at 100% may heat the diode too much, which wears it down. Not sure if that is also the case for the IR laser…