3d Engraving Not Doing All Passes

I am trying to engrave a brass coin. I set it up exactly as shown on the sites video. I set it for 256 passes just as an initial test since I was doing my best to replicate their video.

However it only does a fraction of the passes. I have it set for 256 and it says it should take 2.5hr but it’s finishing in 20 minutes. Not doing all of the passes.

Am I missing something from the video?

Sorry, there are a million videos out there… do you have a link?

:smile_cat:

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.