# 50w Hoatian fiber laser and attempting to fix my rotary issue

**URL:** <https://forum.lightburnsoftware.com/t/50w-hoatian-fiber-laser-and-attempting-to-fix-my-rotary-issue/113423>\
**Category:** LightBurn Software Questions\
**Created:** [October 15, 2023, 1:11am UTC](https://forum.lightburnsoftware.com/t/50w-hoatian-fiber-laser-and-attempting-to-fix-my-rotary-issue/113423 "2023-10-15T01:11:50Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![jkwilborn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/jkwilborn/32/63089_2.png) [@jkwilborn](https://forum.lightburnsoftware.com/u/jkwilborn)\
**Post date:** [October 15, 2023, 8:52pm UTC](https://forum.lightburnsoftware.com/t/50w-hoatian-fiber-laser-and-attempting-to-fix-my-rotary-issue/113423/2 "2023-10-15T20:52:09Z")

</div>

I assume a chuck rotary?

* * *

Steps/rotation should be good since it’s only a wavy line… Do you mind posting your project file so we can look at it’s design and how you are asking the machine to perform the operation.

> [@A rotary attachment question. Warning: Newb](https://forum.lightburnsoftware.com/t/a-rotary-attachment-question-warning-newb/88977/2):
>
> Configuring for a rotary should not be an issue. I’m assuming you are using the Y axes… you didn’t say… find steps/rotation a. identify the switch settings b. translate from the motor driver placard steps/rotation is then computed based on a ratio. a. value entered is steps/rotation multiplied by the ratio which results in the steps/rotation of the wheel, which is what Lightburn needs to know. This is the basic procedure. Look up the settings on the devices pla…

It’s basically the same if it’s for any kind of laser engraver.

😸

---

_[View the full topic](https://forum.lightburnsoftware.com/t/50w-hoatian-fiber-laser-and-attempting-to-fix-my-rotary-issue/113423)._
