good day guys,i need help please.
i have a GK Tools Diy Machine,7500mW Diode laser with eleksmaker controller.
i cant seem to get it to cut anything,at this stage i am using 3mm MDF it only scorches the wood but does not burn through.
i have played with the power and speed settings but nothing helps.
please assist guys i am about to put my full weight on every inch of this machine.

Cutting is tricky.

Try this… air assist is the key

You also need to make sure focus is spot on… MDF is hard to cut as it is dense… Try ply.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.