A software suggestion if I may

A couple of times I have had a small issue unrelated to the software. The issue, I lose connection from the PC to the board. It is usually the power going out on a long project, or the USB gets bumped just enough to disconnect and cause a loss to the board or when the PC goes to sleep. When that happens, The software and laser stop immediately! That causes a need for rehoming and other adjustments. But more importantly, it also loses all progress on the project forcing you to start from the beginning again. Is there a possibility of making the software “Pick up” from a certain point? Or recover from the point of power loss?

Thanks in advance. Love the software so far!

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.