# Air Assist for my Ortur LM3

**URL:** <https://forum.lightburnsoftware.com/t/air-assist-for-my-ortur-lm3/107811>\
**Category:** Ortur Lasers\
**Created:** [August 17, 2023, 12:48pm UTC](https://forum.lightburnsoftware.com/t/air-assist-for-my-ortur-lm3/107811 "2023-08-17T12:48:35Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![AxelOML3](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/a/c89c15/32.png) [@AxelOML3](https://forum.lightburnsoftware.com/u/AxelOML3)\
**Post date:** [August 17, 2023, 12:48pm UTC](https://forum.lightburnsoftware.com/t/air-assist-for-my-ortur-lm3/107811/1 "2023-08-17T12:48:35Z")

</div>

I need to know if I can control my compressor to turn on and off for the respective cut and engrave layers with lightburn. Also need to know if there is any piece of hardware I need to add to my laser or a specific pump. Thanks

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [September 16, 2023, 12:49pm UTC](https://forum.lightburnsoftware.com/t/air-assist-for-my-ortur-lm3/107811/2 "2023-09-16T12:49:06Z")

</div>

Closed on September 16, 2023, 12:49pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.