Hi. I am trying to set up air assist on my Ruida RDC6445G controller. The solenoid is connected to +24V and the STATUS connector, nothing happens. I tried connecting it to the WIND connector and again nothing changed. The voltage on the connectors drops to +3V, but if you connect the solenoid to the…

2 transistors were faulty on the controller board, they were marked as 1P. After searching for the transistor marking on Google, I came across the MMBT2222A transistor I needed. Tonight I soldered out the old faulty transistors and soldered new ones. Now the outputs are working fine, the signal is b…

Air Assist Not Working

LightBurn Hardware Compatibility Ruida controllers

jkwilborn (Jack Wilborn) July 14, 2022, 1:45pm 10

Might peruse this thread…