Air run time after homing

When the laser is done cutting and returns to the home position, the air runs for a long time after homing. Is the a way to cut down the time the air runs after the cutting is done and homed? Usually seems to flow at high pressure air.

1 Like

There are lots of ways to control the air, how is yours wired up?

Solenoid on the left is ‘status’ and enables air… The right one, ‘wind’, bypasses the restrictor.

:smile_cat:

1 Like

I have the Thunder Nova 24 so the controller shuts the air off, just too long of time after the head homes that the air keeps blowing. Wanting to know how to shorten that time.

I understand the question. Without knowing how it’s wired up, I am not able to help you.

:smile_cat:

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.