Alarm 2 on or near Line 2

Not recognizing projects

Not sure what this means so, you will need to rephrase.

The Alarm:2…

Nearly every time we see this with an Ortur setup, it because the user is not in ‘Absolute Coords’ mode for the ‘Start From’ setting. Is that what’s happening here?

I’m not sure what the real problem was either .What I meant by my statement was that I could home and the laser would even fire, but it wouldn’t frame or start the project. I went through and checked all settings, including Absolutes, and they all seemed fine. After a few resets things started working again so I’ll just chalk it up to “one of those things”. Thanks for getting back to me.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.