Anyone turned their 3018 into a 32 bit machine?

I’m going to attempt to modify my sainsmart 3018 to a 32 bit controller. Has anyone done this? I really just don’t want to make any blue smoke, otherwise I think I can handle it…BUT if anyone has done this, did you see an improvement with grey-scale?

Here is a detailed thread about replacing a diode control board with a Cohesion3D LaserBoard:

Why do you think it will get any better with different (better) microcontroller? Especially with gray scale?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.