I don’t see Alarm:14 listed in the possible alarm triggers, here’s the console feedback:
Layer External Cutout Pass 4 of 10
Layer External Cutout Pass 5 of 10
Layer External Cutout Pass 6 of 10
Layer External Cutout Pass 7 of 10
Layer External Cutout Pass 8 of 10
Layer External Cutout Pass 9 of 10
Layer External Cutout Pass 10 of 10
Layer External Cutout Pass 1 of 10
Layer External Cutout Pass 2 of 10
Layer External Cutout Pass 3 of 10
Layer External Cutout Pass 4 of 10
Layer External Cutout Pass 5 of 10
Layer External Cutout Pass 6 of 10
Layer External Cutout Pass 7 of 10
Layer External Cutout Pass 8 of 10
Layer External Cutout Pass 9 of 10
Layer External Cutout Pass 10 of 10
[MSG:check usb lock]
[MSG:check usb lock]
Layer External Cutout Pass 1 of 10
ALARM:14
On or near line 38677:
ALARM:Safe Lock Open
On or near line 38677:
Job halted
Stream completed in 39:38
Grbl 16AAS11A0075-AB-V1.06 [‘$’ for help]
Your Grbl may not support Variable Power mode (M4)
If your laser does not turn off between cuts,
switch to the GRBL-M3 device
[MSG:‘$H’|‘$X’ to unlock]
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
error: GCode cannot be executed in lock or alarm state
[MSG:Caution: Unlocked]
ok