Can anyone help with axis calibration reset ? I had to run axis calibration in lightburns machine settings as my cuts were measuring over .3 of a mm smaller than they shouldve been on the x and y axis. Ive done this b4 with lightburn with no problems, but after todays effort im unable to use the machine. It stuttered when i tried to move it directly afterwards. I turned it off and when i restarted it tried to home in the wrong area and crashed. Its a 100watt chinese blue and white laser with a ruida controller. Is there a way of resetting calibrations back to what they were previously ? Hoping someone can help. Thnx in advance
At the bottom of the Edit → Machine Settings dialog, click the Load from backup button and pick the most recent automatic backup from before you did the calibration.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.