I have laser offset enabled.
I printed a square with its lower left corner at 20mm and 20mm
I measured the offsets at 0.0X and 12.3mmY on my 40W blue module. (Snapmaker a 350)
I entered 12.3mm into the Y offset, leaving the X at zero.
Closed and reopened LB, output the Gcode again, printed and the box did not move on either axis.
I printed on paper, so I can actually overlay the papers with the paper corners aligned, and the before and after prints are directly on top of each other.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.