Burnning photo on Birtch plywood

Does anybody know the best settings for this picture on
birch plywood with 3.8W J-tech laser
I have tried several settings but not get a good burning

In the Cut Settings Editor, have you tried Image Mode: Newsprint?

Yes, and that was not good eitther

I’m new at this too and have only tried one photo. My experience is that you have to do as much pre-processing as possible on the photo (with photoshop/gimp,etc). I think what need to be done will vary with each photo. Maybe you could post a photo of your best burn and people might be able to comment about what you could do?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.