Hello, I’m using an Xtool D1 Pro 20w and the laser camera from Parts Geek.
I installed the camera onto the laser frame then ran the Calibrate Camera Lens program. That all went just fine, I got good numbers.
Next I ran the Calibrate Camera Alignment program. I burned the 4 circles and placed the curser directly where they should.
When done I drew a square on the wood, updated the overlay, and tried to frame it. It was way off, almost 1"
I tried aligning the camera several times using Lightburn but I cannot get the laser to frame or burn where I draw a square.
I don’t know what else to do so any help will be wonderfully appreciated!
Thank you very much.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.