Calibration of laser

I think my setting are wrong, if I position something in the middle of a cut area, say a piece of ply 100 x100 and write a word to be placed in the centre, it shows in the centre of the screen but will engrave in the bottom write corner, which is where I have my origin set

Alfawise C30

This is a diode laser?

Do you have limit switches installed on this machine, with homing? If not, the machine has no idea where it is.

This is some useful information about diode laser setup and addresses the lack of homing common on this machine type:

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.