Camera Alignment Loss

Set up my Lightburn camera and also ran the camera alignment. Results were darned near perfect except now when I close LB or restart the machine my cuts vs what I see in the camera are about 3/16 of an inch off in the Y axis…what am I doing wrong? Do I really need to do a camera alignment every time I want to run the machine?

No, but you do need to make sure the lid opens to the exact same place every time if it’s mounted to the open lid. That’s the only reason it would be off in just the Y direction.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.