# Camera Calibration Crash

**URL:** <https://forum.lightburnsoftware.com/t/camera-calibration-crash/5260>\
**Category:** Cameras\
**Created:** [July 19, 2019, 3:03am UTC](https://forum.lightburnsoftware.com/t/camera-calibration-crash/5260 "2019-07-19T03:03:19Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![kbigmike2121](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/k/a6a055/32.png) [@kbigmike2121](https://forum.lightburnsoftware.com/u/kbigmike2121)\
**Post date:** [July 19, 2019, 3:03am UTC](https://forum.lightburnsoftware.com/t/camera-calibration-crash/5260/1 "2019-07-19T03:03:19Z")

</div>

Hello Everyone:

I’m having a very frustrating issue when trying to calibrate my camera. When I click “Capture” I run into an issue where Lightburn Freezes and I have to close it down. I’ve tried running with Administrator privileges but no luck. I have a Windows 10 Operating System running an LS-1420.

I hope I can get this straightened out as I can not use my camera because of it.

Thanks in advance…

Michael K.

---

<div class="post-metadata">

**Author:** ![LightBurn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/lightburn/32/75577_2.png) [@LightBurn](https://forum.lightburnsoftware.com/u/LightBurn)\
**Post date:** [July 19, 2019, 3:05am UTC](https://forum.lightburnsoftware.com/t/camera-calibration-crash/5260/2 "2019-07-19T03:05:39Z")

</div>

Most likely you have a honeycomb bed, and the camera code is confusing it for a lot of extra circles. If you cover the honeycomb with something (a sheet, some cardboard, wood, etc) it should behave itself.

---

<div class="post-metadata">

**Author:** ![kbigmike2121](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/k/a6a055/32.png) [@kbigmike2121](https://forum.lightburnsoftware.com/u/kbigmike2121)\
**Post date:** [July 19, 2019, 3:08am UTC](https://forum.lightburnsoftware.com/t/camera-calibration-crash/5260/3 "2019-07-19T03:08:50Z")

</div>

Okay, I’ll give that a shot. Thanks for the quick reply!

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [August 18, 2019, 3:08am UTC](https://forum.lightburnsoftware.com/t/camera-calibration-crash/5260/4 "2019-08-18T03:08:55Z")

</div>

Closed on August 18, 2019, 3:08am UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
