I just installed my camera (it isn’t a Lightburn camera from Lightburn). It has a 70-degree FOV. I was able to calibrate it with a score of .40 or better. I was able to align with the image (1, 2, 3, 4 targets) without issue.
I then loaded a junk 4" coaster I had laying around and then imported an image and aligned it on the material. I then set the engraving power and speed and then press START. I started to engrave and half of it was off the material.
Do I need to recalibrate or is there a setting I am missing?
What am I doing wrong?