Hello, all. I haven’t used my laser in a few months. I came out to start a job and I got the update available notification. I finished the job and did the update no issues. I came out today and tried to run a job (first since update) and the laser doesn’t align with the camera. Its a lightburn 8mpx120. So i do an alignment and focus and its still off. The Camera is also not as clear as it used to be. I also noticed a few other things off since the update like i have inches selected but some of my cut settings (not all) are in metric. I have refocused and realigned 4 times and the last 3 it move to the same place to burn about 1.5x1.5 inches off where i selected with the camera. Anyone else have this issue and have a solution? My laser is an 80w omtech24x36 and i haven’t had this issue before.