are there instructions somewhere for installing the lightburn camera on a cohesion 3d card? Not the software setup part but actually where things plug into?
The camera plugs into a USB port on your computer, not the C3D board.
Thats the answer I’ve been looking for. LOL haven’t got my board yet and haven’t seen any instructions for installation so I was a bit confused.
Does the camera only get used when the lid is basically open to do the imaging portion? or are there uses for it when the lid is closed as well?
It’s intended for lining up oddly shaped cuts. You can often still see the laser running with the lid closed, but it’s better to just watch the laser itself.