Can not connect two computers via wifi at the same time to Ortur LM3

Had been experimenting with Lightburn on my laptop. Pulled the trigger and bought a license. Installed 2nd copy on my desktop so that I can burn from either machine. Both laptop and desktop flip back and forth between “Ready” and “Disconnected” unless I exit Lightburn on one. I’m not sure who should be in control here - the software or the hardware.

Software, it tells the hardware what to do.

Are both computers connected to the same laser?

With LightBurn, you can use both computers (or seats) at the same time, but only one communication port can be used at a time with the vast majority of engravers.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.