Changing Scanning Direction

I’m guessing there is a simple answer but I haven’t found it yet. I have a grid I’m trying to engrave, almost like a tic taco toe grid. There are two horizontal lines and 2 vertical lines. If I do all at once, it takes along time because it is going back and forth horizontally up the vertical lines. If I could change the engraving direction to vertical for these, it would save a lot of time. Can anybody tell me how I can fix this?

Thanks!

Select the vertical lines, place them on a different layer and change the angle of scan for that layer in the ‘Cut Settings Editor’ window.

image

1 Like

Literally just found that! Thank you very much, appreciate it!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.