# Chuck Rotary steps aren't changing the rotation

**URL:** <https://forum.lightburnsoftware.com/t/chuck-rotary-steps-arent-changing-the-rotation/75653>\
**Category:** LightBurn Software Questions\
**Tags:** ruida, rotary\
**Created:** [September 5, 2022, 4:32pm UTC](https://forum.lightburnsoftware.com/t/chuck-rotary-steps-arent-changing-the-rotation/75653 "2022-09-05T16:32:46Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![jkwilborn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/jkwilborn/32/63089_2.png) [@jkwilborn](https://forum.lightburnsoftware.com/u/jkwilborn)\
**Post date:** [September 5, 2022, 10:30pm UTC](https://forum.lightburnsoftware.com/t/chuck-rotary-steps-arent-changing-the-rotation/75653/2 "2022-09-05T22:30:47Z")

</div>

Check out this post, general rotary setup… if you still have issues… sing out… 🤪

> [@Rotary steps off since updating to latest version!](https://forum.lightburnsoftware.com/t/rotary-steps-off-since-updating-to-latest-version/75565/8):
>
> Rotary setup is really pretty straight forward… Whatever axes you’re using, read the motor drivers steps/rotation off the switches… Match them up with the placard… My setting is 2000 steps/rotation. With a chuck type, you would use this value in the rotary gui. If it’s a wheel type rotary, you need to apply a ‘ratio’ of the motor to the driving wheel. Mine is 2.5 the motor will turn 2.5 times for the ‘wheel’ to turn one rotation. Steps/rotation is 2.5 \* 2000 …

Good luck

😸

---

_[View the full topic](https://forum.lightburnsoftware.com/t/chuck-rotary-steps-arent-changing-the-rotation/75653)._
