Ciecie drewna atomstack a10 pro ( Wood cutting atomstack a10 pro)

Community Laser Talk
1

Witam mam pytanie odnosnie ciecia drewna "wycinania kształtów "mam atomstack a10 pro 10W i laser nie tnie nawet 2 mm sklejki tylko graweruje jakie ustawienia powinienem zastosowac by wyszlo mi cokolwiek z góry dziękuję i pozdrawiam.

Hello, I have a question about cutting wood “cutting shapes” I have an atomstack a10 pro 10W and the laser does not cut even 2 mm plywood, it only engraves what settings should I use to get anything thank you in advance and best regards.

2

Be certain that you have selected mm / minute for the units of speed for cutting.

I was able to cut through a ‘Door Slab’ which was oak veneer then 1/8" (~3mm) core material and then backed with a bad-side veneer to keep it flat.

Air assist helped greatly.