Circle not complete in preview or burn

Hello, I have a image that when I (alt P) to preview, show incomplete circles in Lightburn. See attached pic of preview. The burn results in the same. This is on an Ortur, GBRL, 20 watt diode laser machine though since its on the preview too, I feel that its something I’m doing wrong in the software and not hardware.

Make sure tabs are not enabled.

Thank you!. I went into the cut layer and saw that tab generation was set to automatic. I hit the clear tab and that took care of them. Perhaps, I hit the “add tabs” icon when I was modifying the nodes…

1 Like