CNC controler card: Mesa 7i96

I’m a happy user of Lightburn. The hardware from NEJE is a kind of toy… No way to adjust Z (focus) after each pass. That is why I would like to put the head on the CNC.
LinuxCnc is not on your listed firmware I’m affraid… Too bad.

The control board, Mesa 7i96, is an “Ethernet Step/Dir Motion Control Interface”. All support software is included.
The 7I96 standard firmware is designed for low overhead real time communication with a host controller so implements a very simple set of IPV4 operations. These operations include ARP reply, ICMP echo reply, and UDP packet receive/send for host data communications. UDP is used so that the 7I96 can be used on a standard network with standard tools for non-real time applications. No fragmentation is allowed so maximum packet size is 1500 bytes.
Any way that Ligntburn communicate via Ethernet?

If not, export via GCode might be the way, if LinuxCnc understand Lightburn GCode… I’ll look at that.

Thanks for your answers