Anyone have a CNC router table. I am looking to get a small one to make light bases. I am looking for around 18” x 20” table 3 axis. I see some out on eBay and Amazon in $3-400.00 range and the they say GRBL so I’m wonder if lightburn will operate them also? Any suggestions on tables?
I successfully operated (to test) a T8 / 1310 CNC with Lightburn.
This milling machine is driven by an arduino clone card with a GRBL 0.9j firmware so I had nothing special to do.
I didn’t take the test any further, especially not looking at whether we could change the direction of rotation of the cutter.
It is a tiny table (13x10 cm) but the principle is the same (I think ?)