Cohesion3d controller

I have 2 questions I have not been able to figure out. This is all very new to me, so I apologize if this is somewhat basic knowledge.

Q1. I would like it if the laser pointer went back to the top left corner after it is done cutting/engraving. How do I make this happen?

Q2. My design does not cut where it is showing on the work area in lightburn. I have set the work area to the size of my bed size, however when I frame the cut, it looks like it’s mirrored.

Your help is much appreciated!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.