Sending a file “Focus Test” from Lightburn 0.9.10 and some of the commands show in the Console as unknown. ex. unknown. “0 Z0”, “S0” the 1st is like it dropped the “G” 2nd.“M1”. Sending to an Ender 3 V2 with Marlin “Bugfix-2.0.x” firmware.
Not always at the same place in the file.
What comms speed (baud rate) are you configured to use?
I would set up for 38400, rather than 9600/19200 or 115k.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.