Hello friends.
There was a power failure and my laser machine went off making a very long cut with many very small parts. My question is: how can I follow the cutting file where it left off? It is very difficult to determine which pieces you have already cut when the design is too tight.
Thank you!
With a Ruida controller, it should do this automatically the moment power is restored. It will say something like, “power interruption - resume?” and if you press the Enter button instead of Esc, it will continue where it left off.
That is a definite for sure. DO not press escape or it will go back to your original position. This just happened to me in the middle of a long white tile burn. 90% done and …uhhhohh power went out for 5 seconds. Came back on and like Oz said you get this message…just hit enter on the ruida pad and it will pick up where it left off.
Was waiting for a power outage mid cut but oddly never happened until today…was wondering if this would work and it does, Yeah…
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.