Continuous stalls

LightBurn Hardware Compatibility Ortur Lasers
1

I am new to lightburn and using an ortur LM2 I keep getting the same error on a bunch of different test images any help would be appreciated.

k

Starting stream

Layer C00 Pass 1 of 5

Detect movement, terminate laser engraving!

Acceleration fluctuation:281

Reset Grbl.

Ortur Laser Master 2 Ready!

OLF 137.

Grbl 1.1f [’$’ for help]

[MSG:’$H’|’$X’ to unlock]

Stream completed in 11:11

Ortur Laser Master 2 Ready!

OLF 137.

Grbl 1.1f [’$’ for help]

[MSG:’$H’|’$X’ to unlock]

error:9

[MSG:Caution: Unlocked]

ok

2

Greetings @gstarwind

That sounds like the Gshock sensor is being triggered

Is it possible your table/Stand isnt solid and the speed of the head itself is causing the machine to think it got bumped?

Reach at support@ortur3dprinter.com so we can diagnose further please?

Regards

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.