Control board swap old laser new source

Hello all, new to this forum. I have recently acquired a fslaser galvo fiber from an auction. After some research I have seen that they use a proprietary software for there lasers. I really dont want to mess with it. I have been using lightburn on my co2 lasers for about 4 years and thought this would be a good deal to get into metal engraving. So far it has been a headache with this machine. Has anyone heard of/done a controller swap in one of these machines so they could use the internals from the machine but not have to use FS control board or Re3 i believe it is called? Can I tear apart the machine and build something to use the laser source and head, Or should I cut my losses and scrap the whole thing and buy something else?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.