Converting Leetro to Ruida so I can use LightBurn, Need Help, please

[rxguru (Dave Fong)]

Need some advice. I switch from Leetro to an Ruida 6445. I believe I have all my wires correct but maybe not.

When I move my laser head from it’s original position, hit the esc button (I believe this should move the head back to it’s original spot) when I do this it does move back to the original spot but it fires the laser as well. I dont think the laser should be firing at this time.

My second issue is I draw a small circle, clicked start and the laser head fires and moves a bit and then draws the circle “without” firing the laser.

Thank you all.

[LightBurn (Oz)]

This was covered recently in another post - took me a moment to find it, but this should help:

Leetro to Ruida Upgrade - problem firing laser

I have a Chinese machine from Rabbit Laser. It came with a Leetro MPC6565 and I decided to change to a Ruida 6442 so I can use Lightburn. I’ve managed to sort out most of the wiring but I’ve got an odd problem with regards to the laser firing. The power supply is a MYJG60L. The pinouts and LED’s are slightly different that what I’ve seen on pictures of this PS on the Internet. The pinouts are labeled H, L, P, G, IN, and 5v. My understanding is that these are fire high, fire low, water prot…

[rxguru (Dave Fong)]

I found the answer in the forums. Here:

Leetro to Ruida Upgrade - problem firing laser

THANK YOU Travisr100! You saved me hours of searching. I switched from Leetro to Ruida as well and had the same exact problem as this. Thanks for posting up your results.

Thanks Travis for posting up your results!

[Bonjour (Bo)]

This does highlight the power of the search.

When doing a Leetro to Ruida upgrade, if you had searched for ‘Leetro to Ruida upgrade’ you would have had this info before you hit the problem.

I did check, and the search function is both easy to find and use.