# Couple issues after 2.0 installed

**URL:** <https://forum.lightburnsoftware.com/t/couple-issues-after-2-0-installed/190038>\
**Category:** LightBurn Software Questions\
**Tags:** cut-setting\
**Created:** [May 24, 2026, 12:14pm UTC](https://forum.lightburnsoftware.com/t/couple-issues-after-2-0-installed/190038 "2026-05-24T12:14:29Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![JeremyW](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/j/3da27b/32.png) [@JeremyW](https://forum.lightburnsoftware.com/u/JeremyW)\
**Post date:** [May 24, 2026, 12:14pm UTC](https://forum.lightburnsoftware.com/t/couple-issues-after-2-0-installed/190038/1 "2026-05-24T12:14:29Z")

</div>

After installing 2.0 all of my settings for each color was changed. Then after 2.1 settings still different than what I have been using.

I also have issue when previewing job. The preview shows the laser moving way past job in both directions. After designing a job roughly 18” wide preview shows laser over traveling feet past each side of job.

I have not ran any job since installing both releases. I don’t know if I can trust software updates. I do not want to crash laser.

Running first gen Mira9 100W

Any help is appreciated

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [June 23, 2026, 12:14pm UTC](https://forum.lightburnsoftware.com/t/couple-issues-after-2-0-installed/190038/2 "2026-06-23T12:14:30Z")

</div>

Closed on June 23, 2026, 12:14pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
