Salve non capisco perché da quando ho aggiornato dalla versione 9.22 alla 9.24 si comporta in questo modo, con la versione precedente non ho nessun problema. Le ho provate tutte , ho cambiato pure PC, cavo usb ma niente sempre lo stesso problema inizia il lavoro e poi si blocca , questo nella modalità buffered, ho messo nella modalità Sincrono e funziona, il problema se voglio incidere una foto va a scatti , sui vettori lavora bene. Firmware GRBL-LPC .Tutto questo con la 9.22 non succedeva. Grazie
Ho caricato un video per capire di cosa parlo.
Hi I don’t understand why since I updated from version 9.22 to 9.24 it behaves this way, with the previous version I have no problem. I have tried them all, I have also changed the PC, USB cable but nothing always the same problem starts the work and then it stops, this in the buffered mode, I put it in the Synchronous mode and it works, the problem if I want to engrave a photo goes jerky, on vectors it works well. Firmware GRBL-LPC. All this did not happen with 9.22. Thank you
I uploaded a video to understand what I’m talking about.