New user. Teaching myself this software and it is tough to figure out. I have the Emblaser2 by Darklylabs. Few questions:
-
Whenever I start a project, the laser never starts cutting/scanning where I think it’s going to. I am really confused on how to make job origin work. And how to tell where the laser is going to cut. Even if I type in coordinates on the grid for the project the laser will start somewhere else usually and I wind up moving the project to chase the laser. How do I properly figure out coordinates and make the laser cut there?
-
How do you make designs and/or convert files to engraving files?
-
How to you reduce laser direction/transition changes?