Laser on my CNC 3018 start acting weird today.
Once I send the project the laser delayed around 5 to 10 to start engraving and delayed another 5 to 10 seconds to move back to the home position. @LightBurn
I did not change anything on the settings.
Please advise me
Check to make sure you don’t have start / end delays set for the layer. There isn’t much I can think of aside from that which would add delays to the run.
There is only one layer.
I created a new topic with more detailes about the machine (VEVOR 20W USB CO2 Laser Engraver)
What DID you change if nothing in the settings was changed? Maybe also check when your operating system was last updated.
Double-click the layer in the ‘Cuts / Layers’ tab to expose the ‘Cut Settings Editor’ window, then click the ‘Advanced’ tab on that panel.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
