Different cut layers coming out off-centre

[ednisley]

@NeilTee

It’s like the cutting is happening 3-5mm across from the engraving.

This can be a peculiar symptom of the Ruida Skewed Engraving config problem:

Configuring a Ruida Controller - LightBurn Documentation

This discussion tracked down a similar problem:

Image shifting and bunching up but cut out is OK

Red-Black 90w Laser Ruida controller engrave 400mm/s 25% Fill 450mm/s 20% Cut 25mm/s 65% Birch ply held down pins belts are tight so are stepper motors When doing a engrave/fill and cut I get the fill shift while the engrave bunches up, cut out in just fine. This is repeatable, and all come out the same, like it was meant to be, how do I attach image?