# Do I need to reset work space?

**URL:** <https://forum.lightburnsoftware.com/t/do-i-need-to-reset-work-space/3934>\
**Category:** Ruida controllers\
**Created:** [May 19, 2019, 5:48pm UTC](https://forum.lightburnsoftware.com/t/do-i-need-to-reset-work-space/3934 "2019-05-19T17:48:24Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Timb](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/timb/32/153_2.png) [@Timb](https://forum.lightburnsoftware.com/u/Timb)\
**Post date:** [May 19, 2019, 5:48pm UTC](https://forum.lightburnsoftware.com/t/do-i-need-to-reset-work-space/3934/1 "2019-05-19T17:48:24Z")

</div>

I was attempting to connect, adjust settings and use the Chuck Rotary … here’s where it gets kind of foggy …

Due to an unknown cause the laser head took off to the right (as I’m facing) the machine and before I could stop it’s movement it pulled the belt out of the clamp. At this point I have no idea why it did this …So I disconnected the Rotary and turned off every toggle that is required to be turned on the use the Rotary and I learned how to reconnect the belt. Once done I powered it up and it heads off to home in the back right corner as usual but it now appears to have lost it’s understanding of it’s boundaries … where it used to stop smoothly on it’s own it now tries to beat it’s self to death and yank out the belt again … I’ve probably put the belt and clamp assy at the laser head back together 6-8 times.

As long as the laser is not allowed to hit the outer limits of it work space I can still cut / fill my work … that’s the good news.

How do I fix this fine mess? Ruida 6442s , latest version of LB 0.9.02 , Chinese 6040

Thank you !!!

---

<div class="post-metadata">

**Author:** ![Timb](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/timb/32/153_2.png) [@Timb](https://forum.lightburnsoftware.com/u/Timb)\
**Post date:** [May 20, 2019, 2:27pm UTC](https://forum.lightburnsoftware.com/t/do-i-need-to-reset-work-space/3934/3 "2019-05-20T14:27:09Z")

</div>

Problem was the Limit Switches were out of position, working fine now.

This is the solution.

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [June 3, 2019, 2:27pm UTC](https://forum.lightburnsoftware.com/t/do-i-need-to-reset-work-space/3934/4 "2019-06-03T14:27:10Z")

</div>

Closed on June 3, 2019, 2:27pm UTC

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.