Does anyone have this problem when the laser pass through an empty space it Continue to shoot the laser?

[Some1love (Haitham)]

Does anyone have this problem when the laser pass through an empty space it Continue to shoot the laser

Is there an option or a switch to stop the laser from firing if it’s gone through an empty space

[Blake (Blake Bartlett)]

Likely this is an issue with your settings. If your controller is running grbl for the firmware, you can type $$ in the console in Lightburn. Paste that info here, and we can take a look.

[LightBurn (Oz)]

Laser not turning off between cuts? (burning during travel moves)

If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …