Engraving mirrior image

[Crg169783 (Coleman)]

Hello,

I have an ender 3 with a lazer attachment.

I ordered a 5w and played with it. Worked good and decided to upgraded to the the 10W.

Set it up as before but the image is mirrored.

I did some looking and home is set to left front.
Also i changed the $3=3 to $3=2 and it fixed the problem but created more. It doesnt know where home is and wants to keep pushing the head outsied the table causing the belts to slip violenty.

Changed back to $3=3 and its back to knowing where home is and doest try to move outside its limits

Any input would be greatly appreciated

Thanks

[Dskall (D Kallenberger)]

Is your origin also at lower left?

[Crg169783 (Coleman)]

Yes

Just checked with theese settings it works fine just in mirror

[Dskall (D Kallenberger)]

Are both the screen and lasered image mirrored?

[Crg169783 (Coleman)]

Screen is normal.

[Dskall (D Kallenberger)]

Read thru this and see if it helps.
Laser engraving mirrored image - LightBurn Software Questions - LightBurn Software Forum