Our shop was struck by lightning several weeks taking out the network and almost everything connected to it. Replaced the RDC6442G-B controller on the 80W 28’‘x20’’ CO2 Laser with a RDC6445G controller. Everything seems to work except for the engraving overrun. To engrave a single object, the laser travels about 6-7" on both sides of the engraving area. This adds significantly to the time to completion. Before the lightning strike, it maybe overran 1/4 - 1/2". What is the setting in the controller that controls the overrun? Thks
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.