error:1 G-code words consist of a letter and a value. Letter was not found

LightBurn Software Questions OS Specific
1

Hello since two days I get this error [G-code words consist of a letter and a value. Letter was not found

on any project I try to cut… it runs after pushing start and after some minutes the laser stops

here is the gcode from the last try

error:1

G-code words consist of a letter and a value. Letter was not found.

On or near line 226:

Job halted
rakete.txt (37.5 KB)

Stream completed in 1:13

2

Go to Edit->Device Settings and disable “Gcode clustering”. Retest please.

3 Likes
3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.