Error: 2 Numeric value format is not valid or missing an expected value. On or near line 0: Job halted

LightBurn Hardware Compatibility
1

Using the cutting function, the machine cuts out the first piece, but does not cut the next ones. When engraving, the machine stops immediately. As an error, lightburn reports “error:2 Numeric value format is not valid or missing an expected value. On or near line 0: Job halted”. I would be very grateful if you could guide me where the numerical error might be.

Hi John. I got a solution to the problem. I had something written in the Gcode tab. Device Settings->Gcode tab.

2

This is usually caused by a mismatched Device Profile or by a communication error.

I’d like to know if you overcame this error and how.

I’d also like to roll back the deleted message to allow others an opportunity to find solutions by searching here on the Forum.