Error 5 Homing cycle is not enabled in your Grbl settings.After using Rotary. I have the Ortur laser master 2 with the micro switch. I went to go print a tile set everything back like turning off rotary tag and enable homing on start up. I tried opening system files and deleting the folder and the 2 files that were in there. I opened lightburn after restarting my computer. It was like a new set up which was fine it asked for orientation of switch and found my device. but still getting Error. My plan was to make 2 profiles one for regular stuff then 2nd one for Rotary.
Any help would be much appreciated.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.