Error message when starting a job

Good day,

I recently bought a LM3 machine and had trouble with it not powering on. I re-assembled it and it powers on now.
When i try and start a project though i keep getting this error message:

Ortur Laser Master 3 Ready!
OLF:206.
OLH:OLM_ESP_PRO_V2.4B.
OLM:GENERAL.
GrblHAL 1.1f [‘$’ or ‘$HELP’ for help]
[MSG:‘$H’|‘$X’ to unlock]
[MSG:3:Caution: Unlocked]
ok
G-code locked out during alarm or jog state. error:9

The machine will only move sideways and not up and down.
When i switch it on it also does not go to the home position.

Any advice is welcome.
Thanks
Warren

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.